Floor Flange for 34mm Galvanised Pipe 27mm Galvanised is usually used to form

is usually used to form roof structures in conjunction with type 185

The 152 Slope Base Flange D48 is a base flange for sloping sites

and is suitable for above ground use

The 156 Slope Cross (Middle Rail) is adjustable for slopes from 0 degree to 11 degree

and normally used to join intermediate uprights to top rails and middle rails to end uprights

Floor Flange for 34mm Galvanised Pipe 27mm Galvanised is usually used to formWhere would you normally use this galvanised pipe fitting? The 132 is a base flange, usually used for uprights on level sites. Fixing holes suit a wide range of common mechanical and chemical masonry anchors. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 34mm. What is it made out of? All of the pipe fittings are made from malleable iron and then hot dipped galvanised to exceed