3535-38 Taper Locking Bush 38mm Bore Open The pulley grooves are of

The pulley grooves are of a special design to give this correct meshing of the timing belt teeth with minimal friction

The product is particularly suitable for use on aluminium substrates where very good adhesion is needed

Outside diameter B: 150mm

meets BS 6920 for potable water: 0706521

Cures on active and inactive metals

3535-38 Taper Locking Bush 38mm Bore Open The pulley grooves are ofTaper bushes are the most convenient and cost effective method of fixing components to a mating shaft without using any special tools Bore dia: 38mm Keyway width: 10mm Keyway depth: 3. 3mm Shallow keyway depth: Screw tightening torque (Nm): 115 Screw size (BSW): 1 2 inch, hex, socket size: 10mm Large end dia: 127mm Bush length: 89mm Mass: 5. 0kg To Install: 1. Clean shaft, bore and outside of bush, and bore of hub. Remove any oil, laquer or dirt,